-40%
EVERCOAT 425 METAL GLAZE ULTRA POLYESTER FINISHING AND BLENDING PUTTY (QUART)
EVERCOAT 425 METAL GLAZE ULTRA POLYESTER FINISHING AND BLENDING PUTTY (QUART)

EVERCOAT 425 METAL GLAZE ULTRA POLYESTER FINISHING AND BLENDING PUTTY (QUART)

$ 18.74

Availability: 141 in stock
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Item must be returned within: 30 Days
  • Country/Region of Manufacture: United States
  • Restocking Fee: 15%
  • Returns Accepted: Returns Accepted
  • Return shipping will be paid by: Buyer
  • Condition: New
  • Brand: Evercoat
  • Manufacturer Part Number: 425, 416,412,407,125,112,106,156,282
  • Warranty: No Warranty

    Description

    EVERCOAT 425 METAL GLAZE ULTRA POLYESTER FINISHING AND BLENDING PUTTY (QUART)
    METAL GLAZE  Ultra is the world’s best sanding polyester putty for use as a finishing coat over body filler, large panels, or small spot filling. Its unparalleled sanding qualities are a result of the patent pending EcoResin. Its unique thinner viscosity makes it ideally suited for intermixing with other Metalworks  products to improve flowout. Formulated with ZNX-7 for improved adhesion.
    USES:
    Use as a finish coat over body filler repair areas to fill minor defects, deep sand scratches and pinholes prior to applying primer surfacer to improve the efficiency of the primer coat. Can also be used to fill minor body damage up to 1/8” in depth.
    APPROVED SUBSTRATES:
    Steel, Galvanized and other zinc coated steel, and most rigid to semi-rigid fiberglass and thermo set plastics. For flexible plastics, use POLY-FLEX™ Flexible Polyester Glazing Putty.
    PREPARATION:
    Clean surface. Remove all dirt, oil grease and wax. Use an 80—180 grit disc to remove or scuff paint. Surface must be completely dry before application.
    MIXING:
    Place desired amount of putty on a clean, non-fibrous mixing board. Add a ribbon of cream hardener from edge to edge across the center of dispensed putty. Puddles larger than 4” in diameter will require additional hardener. Mix thoroughly until uniform color is achieved. Approximate setting time is 5-6 minutes @ 75 to 80F (27C).
    APPLICATION:
    Spread a thin layer of mixed material over surface using firm pressure to ensure best adhesion. Apply additional layers building area slightly higher than the surface to allow for sanding. Do not apply over fresh or uncured coatings.
    FINISH:
    Sandable in approximately 20 minutes. Sand hardened putty with 180-220 grit sandpaper followed by 320 grit, if desired.
    YOU WILL RECEIVE 1 QUART OF EVERCOAT METAL GLAZE ULTRA WITH 1 TUBE OF BLUE HARDENER.
    PROVISION Auto Body Supply
    Providing Quality to Professionals. Buy with confidence.